On the front of the engine, there are a number propelling rubber belt, the buckle for different roles, while driving the generator on the a / c compressor. Rubber die, in extreme conditions, such as the operating system in an engine compartment. Please note that your belt drive and accessories belt control all 25000 km, rather than replacing all 50000 miles.
It's a bit what everybody can do it - it's quick and easy and it will tell you if your engine needs oil. If the oil is too low or too high, it may be problems for your engine. In order to check the oil, Park flat on the floor and wait until the engine is cooled by the trip, then research on the reading of Staff. Unplug it and clean it well, and then push it back all the way into the head, it is well established in the sub-dip. Wait a moment, then backwards. Check the oil level. When it between high and low-brands that you know very well. (If it is too low, you add a little.) High-and low-brands can be described by two points, a "H" and "L" or a shaded area to the headquarters of measurement. The photos below show a measure of Staff of Honda, the two points. Why not read, the first tier of time? The first time, when you use the pull-Meßstab, it is quite oil, and it will be difficult to tell where the plain. That's why you have to dry them on a towel, a measure HQ, and then they dive in the oil to get a good reading.
It's a bit what everybody can do it - it's quick and easy and it will tell you if your engine needs oil. If the oil is too low or too high, it may be problems for your engine. In order to check the oil, Park flat on the floor and wait until the engine is cooled by the trip, then research on the reading of Staff. Unplug it and clean it well, and then push it back all the way into the head, it is well established in the sub-dip. Wait a moment, then backwards. Check the oil level. When it between high and low-brands that you know very well. (If it is too low, you add a little.) High-and low-brands can be described by two points, a "H" and "L" or a shaded area to the headquarters of measurement. The photos below show a measure of Staff of Honda, the two points. Why not read, the first tier of time? The first time, when you use the pull-Meßstab, it is quite oil, and it will be difficult to tell where the plain. That's why you have to dry them on a towel, a measure HQ, and then they dive in the oil to get a good reading.